Rome column can choose to copy the mold silicone it?

Rome column can choose to copy the mold silicone it?

Many manufacturers in the production of Rome column often choose what kind of mold puzzled, resin mold? Silicone mold? Steel mould?

In fact, we can from the Roman column component itself to analysis, Roman column is generally used special resin (also known as glass fiber reinforced plastic resin), gypsum powder, sand and other materials from refined. Therefore, it has a certain hardness, and appearance will need some pattern and so replicate lines will die has certain requirements, obvious use of silicone mold has more advantages, although short-term resin mold may slightly lower cost but from long term silicone mold more durability and operability, especially for complex lines have more finesse of Roman column, silica gel mould is better choice.

Rome column mold silica gel is the product of Rome column replication with silicone. It can be used to copy the Roman column, relief furniture, stationery, gifts, plastic toys, building decoration, cultural relic, large sculpture, sandstone, relief, Roman column, glass steel, simulation cultural stone, marble, rockery, sandstone mold production.

Characteristics of silica gel in Rome column:

1, with no deformation, high temperature, acid and alkali, not the characteristics of expansion.

2, the shrinkage rate is good, the number of complex mold, mold silicone shrinkage rate of 2/1000.

3, tensile strength, good elasticity, good tear, not only to your products beautiful, but also enables you to make products not deformation, high temperature in a 200 degree are not the problem, minus 50 degrees silicone mould is still not brittle, still very soft. Simulation results very well.

Rome column mold silica gel for white liquid, the general product after curing, hardness is 22 - 50A degrees. Roman column large majority, there are some small parts and spare parts, if customers need to do large products, such as mold, mold with high hardness of the silicone rubber mould, instead, intricate and fine tiny mold, such as packet mode, must be to do with the soft silicone mold mold. The amount of curing agent can be determined according to the actual requirements of customers, the requirements of rapid drying, rapid de mold, the corresponding to more curing agent. On the contrary, a little slow release, a little less curing agent (but the amount of curing agent can not be added up to more than 5%).

If you want to know more new silicone raw material products, liquid silicone rubber, silicone mold, crafts mold silicone rubber, palm silica gel, silicone mold production related products, technical knowledge, please pay attention to our easy good silica gel official website: http://www.sz1j3.com/ can also be toll free hotline: 0755-85200989, welcome you to contact us at any time, us to good will wholeheartedly for your service!